JERMAN ENGINEERING
← Back to the product
The engineering

The extra step

Similar products exist. The difference here is the testing: every feature was printed, broken, measured and changed. I'm Jerrekt, an engineering student at SJSU.

design versions
13
joint hold with no magnets
2.4 kg
14.511.310.39.5 mm
Trunk to plate back, across three height cuts. Bars are to scale with each other.

Design decisions

The plate releases first, on purpose

The joint is sized so the plate lets go before the car bar does. A tighter fit held twice as hard in testing, and was rejected for that reason.

Plastic takes the load

Magnets pull hard straight on but slide sideways. Interlocking plastic takes the sideways and up-down loads, so the magnets only hold the joint closed.

ASA, not PLA

PLA can soften on a hot trunk. ASA is an outdoor plastic that holds its shape in heat and sun.

Low profile

Three rounds of height cuts took the stack from 14.5 mm to 9.5 mm.

Tape now, magnets later

The tape kit mounts to most vehicles with 3M tape. A magnet mount for steel trunks, with a soft pad between the bar and the paint, is coming later.

How it was built

What was dialled inTriesResult
Overall design13 versionsv6
Stack height3 cuts14.5 → 11.3 → 10.3 → 9.5 mm
Big-magnet pocket3 designs + 1 test roundLight press fit; magnet sits flush
ASA flow calibration2 passesTuned to this exact filament
Supports under the pocket roof4 settingsClean roof, magnet flush
Joint fit11 variants, 4 roundsFit locked from pull tests
TPU grip pad6 designs0.2 mm keyed pad
Pull-test fixture3 versionsBolt-down deck, so nothing squeezes the joint under test

Testing

Measured

Joint pull-off, no magnets

Straight pull on a fresh joint, luggage scale, printed test fixture.

Shipping fit2.36–2.50 kg
Earlier ribbed design2.47 kg
Tighter fit (rejected)4.80–5.36 kg

The tighter fit held twice as hard, which is why it was rejected: the plate has to let go before the car bar does.

Measured

Trunk-slam slide

Hard trunk slams on bare paint, slide measured after each.

No grip pad3–5 mm / slam
0.2 mm TPU pad1–2 mm / slam

Target: under 1 mm per slam. v6 adds six more trunk magnets for it.

In progress

Full-kit tests on v6

  • Straight pull: acceleration and wind load
  • 45° pull: a pothole at speed
  • Slide pull along the trunk, plus slams
  • 100 on-off cycles for wear

[RESULTS]

Honest about wear

Like any snap fit, the joint will loosen slowly with use. Wear testing on the full kit is next, and once it's done I'll post a recommended refresh point here. Returning buyers get 30% off a refresh kit.

Order yours